MODSTER EASY 800 TRAINER, Руководство пользователя

Страница: 34 / 40

Manual MODSTER Easy Trainer 800
34 www.modster.at
11.2 Grundparameter
1. designed for fixed-wing models, multicopters and ground vehicles
2. transmission power: less than or equal to 70mW
3. transmission frequency: 2420 MHZ---2459 MHZ
4. ground control range: greater than 300 metres
5. transmitter power supply requirements: DC+6V (4 AA batteries)
6. receiver power supply requirements: DC+6V
11.2 Quick guide for transmitter and receiver
1. switch off the transmitter, connect the signal line of the controller to the third channel of the receiver and then connect the battery
to the controller. 2.
2. the orange status light flashes slowly when the receiver is switched on. 3.
3. press the binding switch with a small pointed object - the orange status light will flash quickly. 4.
4. return the throttle to the lowest position and switch on the transmitter. Once the transmitter and receiver are paired, the status light
on the receiver will be solid. 5.
5. switch off the entire system, connect all servos according to the flight manual. Make sure the polarity of each connector is correct. 6.
6. Move each control stick and check that the servos respond in the correct direction. 7.
7. Repeat the previous steps if the system does not work properly.
*Note: The M. Bus channel is connected to the flight controller via a servo harness.