MODSTER 4260668081612, Руководство пользователя

Страница: 25 / 34

F
Manual - MODSTER Compass
www.modster.at 25
Tie the other end of the cord to
a clevis through a bowsie, then
hook the clevis to the eyelet of
jib boom as shown in picture.
Unleash the Dyneema cord circled on jib boom, then lead it through three eyelets on deck as shown in
picture, finally tie it on the pre-installed clevis at the end of the port.
Unleash the Dyneema cord circled on main boom, then lead it through the cord holder and eyelet on
deck, then finally tie on the pre-installed clevis at the end port.
Move Silicone Rings („SR“ for short) to appropriate position as shown in picture.
If further rigging needed, adjust refering to below instruction:
1. Move SR1 to adjust main sail until it is appropriately tight, but leaving little bending room so that it
can sail. Normally if in strong wind environment it needs more bending room, in gentle wind envi-
ronment it needs less bending room.
2. Move SR2 to adjust the Dyneema cord tied in step 13 if it is too tight (move to SR3 direction) or too
loose (move to SR1 direction), in order to keep the main boom in center position.
3. Normally you don‘t need to move SR3, keep it in the position as shown in picture.
Hook the clevis to the forestay
fitting part, keep its eyelet
pointing parallel with the hull.
Cut a length of Dyneema cord
at about 200mm, tie on end on
SR7, then lead the cord through
a bowsie and eyelets on deck as
shown in picture.