3
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
247 - LED Vanities & Wall Sconces
WS-24718, WS-24727, WS-24736
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
INSTALLATION
MOUNT ON SWITCH BOX (Fig. 1)
3. Remove the mounting screws (C1) from the fixture.
4. Drill holes in the wall aligned with the key hole located in the mounting plate, insert the plastic anchor (D1).
5. Connect the driver (F1) input wire to switch box wires as shown in Fig. 3, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare cooper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground
wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the switch box.
*Required Driver to be recessed within the switch box.
6. Secure the mounting plate to the switch box using the junction box screws (B1), fasten it to the wall using wood screws (E1) and
spacers (I1). The side of the mounting plate marked “GND” must face out.
7. Pull-out the driver’s output wire, secure it to fixture wire as shown in Fig. 3. making sure that all wire connectors (K1) are secured.
8. Place the fixture over the mounting plate, and secure it with mounting screws (C1).
OR
MOUNT ON JUNCTION BOX (Fig. 2)
3. Remove the mounting screws (C1) from the fixture.
4. Drill holes in the wall aligned with the key hole located in the mounting plate, insert the plastic anchor (D1)
5. Connect the driver (F1) input wire to junction box wires as shown in Fig. 3, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare cooper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground
wire directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the switch box.
*Required Driver to be recessed within the junction box.
6. Secure the mounting ring (G1) to the junction box using the junction box screws (B1). Make sure the two holes (Spacing 2-3/4”) are
horizontal as shown in Fig. 2. The side of the mounting plate marked “GND” must face out.
7. Secure the mounting plate and conversion plate (J1) to the mounting ring with screws (H1). Fasten the mounting plate to the wall using
wood screws (E1) and spacers (I1).
8. Pull-out the driver’s output wire, secure it to fixture wire as shown in Fig. 3, making sure that all wire connectors (K1) are secured.
9. Place the fixture over the mounting plate, and secure it with mounting screws (C1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 3 Wiring
