INSTALLATION INSTRUCTIONS
F-WCBT-WT
SAFETY RULES
For operation, maintenance, and troubleshooting information,
visit modernforms.com/help.
1. To reduce the risk of electric shock, ensure electricity has
been turned off at the circuit breaker before beginning.
2. All wiring must be in accordance with the National
Electrical Code “ANSI/NFPA 70” and local electrical
codes. Electrical installation should be performed
by a licensed electrician.
CAUTION: If you feel you do not have enough wiring
knowledge or experience, have your RF wall control installed
by a licensed electrician.
NOTE: A maximum of 2 fans can operate on a circuit through
the supplied wall control.
NOTE: A maximum of 12 fans can operate on a circuit through
an on/off switch or a breaker when utilizing the Modern Forms
app for the fan control (without the wall control in the circuit).
Installing the Wall Control
CAUTION: To prevent electrical shock, ensure electricity has
been turned off at the circuit breaker before beginning.
NOTE: Fan(s) are required to be installed within 30 feet of
the wall control to ensure reliable communication.
NOTE: Wall control is intended for indoor installation only.
NOTE: A maximum of 10 remote controls or wall controls
can be used with a fan.
WALL CONTROL TO WALL OUTLET BOX ELECTRICAL
CONNECTIONS
1. Connect the green wire marked “GROUND” from the wall
control to the copper wire from the wall outlet box that
feeds back to the circuit breaker – important for proper
fan function.
2. Connect the black wire marked “LINE IN” from the wall
control to the black LINE VOLTAGE wire from the wall
outlet box that feeds back to the circuit breaker.
3. Connect the red wire from the wall control to the black wire
from the wall outlet box that feeds up to the fan.
1
Remember to disconnect the power at the circuit breaker.
1. Carefully tuck the wire connections inside the outlet
box. Secure the wall control with the two (2) wall
control screws provided.
2. Attach the wall mounting plate over the wall switch
and secure with the two (2) wall mounting plate
screws provided.
3. Fasten the wall plate to the wall mounting plate.
White
White
Red
Black
Green (Ground)
Black (to fan)
Copper
Ground
White
(Neutral)
Black (from breaker)
Wall control
Wall outlet box
4. Connect the white wire from the wall control to the
white (neutral) wire from the wall outlet box.
Wall Control Operation
Restore power to ceiling fan and test wall control as below for
proper operation.
PARING THE WALL CONTROL TO YOUR FAN
Your fan is pre-paired at the factory. No pairing is necessary.
NOTE: For pairing instructions please skip to section 3.
WALL CONTROL BUTTON FUNCTIONS
button: Turns the light ON or OFF.
Press or hold to increase the light level.
Press or hold to decrease the light level.
button: Turns the fan ON or OFF.
Press or hold the button to increase fan speed.
Press or hold the button to decrease fan speed.
ON-OFF Switch: Pull tab to power off in
case of emergency. Not necessary for normal
fan operation.
button: Switch between Summer and Winter Mode.
SUMMER MODE (Counter-Clockwise):
A downward airflow creates a cooling
effect. This allows you to set
your air conditioner on a warmer
setting without affecting your comfort.
WINTER MODE
(Clockwise):
An upward airflow moves warm
air off the ceiling area and
re-distributes the warm air that hovers
around the ceiling to the living space.
This should allow for savings on
heating costs.
NOTE: To operate the reverse button on your fan,
press the button while the fan is running
2
ON-OFF Switch
NOTE: Your fan features 6 speeds. An audible tone will
indicate when the speed is increased or decreased. When
the fan has reached the minimum maximum speed level
the fan will beep twice.
