2
INSTALLATION INSTRUCTIONS
FM-25814
Phone (800) 526.2588
Fax (800) 526.2585
44 Harbor Park Drive
Port Washington, NY 11050
1600 Distribution Ct
Lithia Springs, GA 30122
1750 Archibald Avenue
Ontario, CA 91760
111
1. Shut off the power at the circuit breaker and remove existing fixture,
including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Be careful not to lose any small parts necessary for installation.
. 2 3#,- 45
3. Remove the mounting ring from the fixture.
4. Secure the mounting ring to the junction box using standard junction
box screws that comes with the junction box.
the side of the mounting plate marked “GND” must face out.
. / 3#,- 5
5. Connect the fixture’s wires to house wires as shown in Fig.2,
making sure that all wire connectors (A) are secured. If your
outlet box has a green or bare copper ground wire, connect
the fixture’s ground wire to it. Otherwise, tuck the fixture’s
ground wire directly to the fixture. After wires are connected,
tuck them carefully inside the junction box.
1. /
6. Secure the back plate to the mounting ring using the assembly screw .
7. Place the sparking glass into the bracket, secure them to the back plate
with mounting screw (B) .
∅4"
134"
138"
GN
D
Black or
Smooth
White or
Ribbed
Bare wire
(Ground)
Black
(Hot)
White
(Neutral)
Green or Bare Copper
(Ground)
#,- ##,
#, #, #6 #
#,-4
Junction Box
Screw
Assembly
Screw
Sparkling Glass
RPL-GLA-25814
Mounting Screw
B
Junction Box
Mounting Ring
Black
Wire
White
Wire
Wire Connector
A
Ground Wire
Bracket
Back Plate
