Modern Flames Landscape Pro Slim Series, Инструкция по установке и эксплуатации

Страница: 9 / 16

9
OPERATION
OPERATION
This will cycle the machine on and off. Upon cycling
power on, the machine will return to the settings it had
when it was cycled off.
If the fireplace is on, this button will act as a reset and
bring all colors back to the default Modern Flames'
signature color.
This will cycle the heater between high, low and off.
All zones of the fireplace will slowly fade between
various colors.
Pressing the sync button will change all the colors of
the fireplace) Flame, Ember Bed and Downlight) to
match the current color of the flame setting.
This is a zone setting. Touching this button will allow
you to change the color and brightness of the flame by
using the RGB wheel and brightness slider.
This is a zone setting that controls the color and
brightness of the ember bed.
This is a zone setting that controls the color and
brightness of the downlight.
The unit has a main power switch just in front of the glass on the top right hand side. A hand-held remote
is included.
Power indicator lights for wall switch as well
as upper right corner of the main unit
When the switch turns on, this orange pilot lamp
turns on. It shows the fire is energized.
The status light above shows that the power is on
and the heater is on low. (2500 BTU)
The status light above shows that the power is on
and the heater is on high. (5000 BTU)
Pairing remote/wall mounted touch control:
1. With the fireplace ON press and hold the Power button for about 3 seconds until you hear the buzzer
sound twice and the power indicators begin to flash.
2. Within 5 seconds on the hand held remote or wall touch control press the Power button repeatedly
until the buzzer sounds again and the indicators flash acknowledging that it has paired. You may also
hear another buzzer and the pair is now completed.
• Pairing must be done within 5 seconds or the fireplace will time out of pairing mode.
• To clear any paired remotes from the unit, locate then press and hold the reset button for 3 seconds.
You should hear a buzzer letting you know the codes have been cleared so you can now pair a new
remote or wall touch control. (The reset is located next to the manual controls and can be pressed
with a paper clip.)
Power
Reset
Heat
Fade
Sync
Flame
Ember
Bed
Downlight
Manual Controls
The unit has manual controls located next to the
power switch, just in front of the glass on the top
right side.
Power
Turns unit
on/off
Heat
Cycles
heat low/
high/off
Color
Changes
all
fireplace
colors
together
Reset
Resets
unit