Modena CG 3180, Руководство пользователя

Страница: 5 / 8

5
Start-up of the cabinet
Before use, we recommend that the cabinet is cleaned, see the section on maintenance and cleaning.
Important!
If the cabinet has been vertically placed during transport, please wait for 2 hours
before starting up the cabinet.
Connect the cabinet to a socket and turn on the switch on the control panel, see
Picture 1.9.
Thermostat
The thermostat is placed in the control panel, see Picture 2.0.
The thermostat has been pre-set and in most cases it is not necessary to adjust the settings. When turning on the
cabinet the display will show the current temperature in the cabinet.
Display set temperature:
Press this button and the display will show the set temperature. Press the button again to return to
normal reading.
Set new temperature:
Press this button continuously for more than 3 seconds and the display shows the set temperature.
Press this button to increase the set temperature.
Press this button to lower the set temperature.
Press this button to save the new settings. The display will flash with the new value and will
then return to normal reading.
Alarm codes:
‘P1’
Flashing in the display: indicates that the cabinet sensor is defective.
The cabinet will strive to keep the set temperature until it has been repaired.
‘P2’
Flashing in the display: indicates that the evaporator sensor is defective.
This does not influence the operation of the cabinet, but should be repaired as soon as possible .
Defrosting
The cabinet defrosts automatically with pre-set intervals. If the door to the cabinet is opened or the contents of the
cabinet are changed frequently it may become necessary to defrost the cabinet manually.
Pressing this key continuously for more than 3 seconds will start a manual defrosting and then
return to normal operation.
Defrosted water runs to a container placed in the compressor compartment and evaporates .
Part 3: How to Use
Picture 1.9
Picture 2.0