SECTION 1 – Mount Hardware and Wire Power
Please refer to DRAWING 1 and DRAWING 2.
Orient the box with 3/4” hole nearest you facing down.
SLEEVE LUG
TIP LUG
Output Jack
RING LUG
SLEEVE LUG
TIP LUG
Input Jack
6
Alignment
Tab
1
5
6
7
2 3 4
Mount the DC power jack in the 15/32" hole on the left side of the enclosure.
Orient its solder lugs so that the center-pin lug is facing the bottom side of the
enclosure.
CENTER-PIN LUG
POSITIVE-SWITCH LUG
POSITIVE LUG
Strip and tin a 2 ½” piece of wire and connect the center-pin of the DC power jack to the
sleeve lug of the input jack.
Solder the center pin connection now.
Strip and tin a 4 ½” piece of wire and connect the positive lug of DC power jack to #7.
Solder the
positive lug connection now.
Locate the battery clip. Connect the red wire to the positive-switch lug of the DC power jack. Connect the
black wire to the ring lug of the input jack.
Solder both connections now.
Mount the LED footswitch to the ¾” hole. Be sure to orient the LED leads
towards the 100K pot with C on the left and Ab on the right.
You must remove the button cap with a hex key before mounting. Try to position the
switch so that it is closest to the top edge of the hole without leaving any gaps. This is
to give enough room for the battery.
1
2
3
4
5
6
7
8
9
C
A
b
A
r
Mount input jack in 3/8" hole on left side of box with hardware provided.
Washer goes under nut on outside of box. Make sure to orient the jack as shown in Drawing 2.
When positioned correctly, tighten nut.
Mount output jack in 3/8" hole on right side of box with hardware provided.
Washer goes under nut on outside of box. Make sure to orient the jack as shown in Drawing
2. When positioned correctly, tighten nut.
SECTION 2 – Mount Wires and Selected Components
Please refer to DRAWING 3.
Strip and tin a 2” piece of wire and connect the sleeve lug of the output jack to pin C on the footswitch.
Solder both connections now. Be careful not to put heat on the black plastic divider on the footswitch
LED leads.
Connect the 1k resistor from lug 4 of the footswitch to the A
b
lead of the footswitch for a blue indicator
light.
Solder both connections now. Be careful not to put heat on the black plastic divider on the
footswitch LED leads.
Mount the 100KA pot in the 9/32" hole on the top of the enclosure.
Bend back and remove the alignment tab on the top of the potentiometer using a pair of
pliers before mounting the pot so that it can mount flush against the enclosure surface.
Mount the 5 lug and 2 lug terminal strips to the 1/8" hole as shown in drawing 2
using the #4 screw nut and lock washer. The lock washer goes under the nut inside
the chassis.
Be sure that no lugs are touching the sides of the box. We will refer to terminal numbers 1
through 7 as #1, #2, etc.