11
Tube Pin 6 & Terminal #15
12) Strip ¾” of insulation from the end of the wire supply and tin. Snip off the ¾” piece of tinned
wire and connect:
SECTION 6 – Mounting Components in the Vacuum Tube Section
Please refer to DRAWING 5.
1) Mount the 25
µ
F cap to the input jack’s ground lug and 1KL pot lug 2.
Make sure the negative (-) end of the cap is connected to ground.
Negative
End
25
µF 25
V
1KL Pot lug 1 & Terminal #12
2) Connect the 220 Ω resistor to:
Terminals #10 & #13
3) Connect the 150K resistor to:
Terminals #10 & #11
4) Connect the 200K resistor to:
Tube pin 6 & Terminal #14
5) Connect the 110K resistor to:
Tube pin 7 & Terminal #18
6) Connect the 680K resistor to:
-You can solder the Pin 6 connection, now.
-Don’t solder at Pin 6, yet.
-Don’t solder at Pin 7, yet.
Tube pin 1 & Terminal #16
7) Connect the 220K resistor to:
-Don’t solder at Pin 1, yet.
Tube pins 1 & 7
8) Connect a .1
µ
F cap to:
-You can solder the Pins 1 & 7 connections, now.
Toggle switch lug 1 to Terminal #10
6) Strip and tin a 1" piece of wire and connect:
Toggle switch lug 2 to Terminal #11
7) Strip and tin a 1 ½” piece of wire and connect:
1KL pot lug 3 to Terminal #13
8) Strip and tin a 1 ½” piece of wire and connect:
Terminals #2 & #11
9) Strip and tin a 2 ½” piece of wire and connect:
Terminals #3 & #12
10) Strip and tin a 1 ¾” piece of wire and connect:
Tube Pin 8 & Terminal #18
11) Strip and tin a 2" piece of wire and connect: