10
Connect the remaining 100
µ
F cap to terminals #17 and #19.
Make sure the negative (-) end is connected to #19.
100
µF 25
V
negative end
Press the metal mounting tabs of the transformer inward so they are
flush with the bottom of the transformer. Now place the transformer
upside down in the enclosure in the area shown on DRAWING 4.
The side marked “P” should be facing the top side of the enclosure.
With the transformer resting upside down, insert its three leads facing the bottom side of the
enclosure through terminals #23, #24 and #25, but do not solder.
Only two of the three leads on the “P” side of the transformer will be used. Connect the lead on
the left side to terminal #18. Connect the lead on the right side to terminal #21.
Carefully clip off the remaining unused middle lead on the “P” side of the transformer and solder
the three transformer lead connections at terminals #23, #24 and #25.
Connect the remaining 33
µ
F cap to terminals #20 and #21. Make sure the negative (-) end is
connected to #21.
Connect one of the 1N34A diodes to terminal #23 and the
500KA pot’s lug 1. Make sure the black (cathode) end
connects to the pot lug 1.
Do not solder the Pot lug 1
connection, yet.
cathode end
anode end
Connect the remaining 1N34A diode to terminal #22 and lug 1 of the 500KA pot (also with the
cathode end at lug 1).
Now solder the connection at lug 1.
SECTION 4 – Finishing Up
Attach the knobs provided to the two potentiometer shafts. Install 9 volt battery, close cover using
screws provided. Plug guitar into input jack on right. This turns unit on. Plug cable into output jack
and plug into your amplifier.
Unplug from the input jack of the unit to turn it off and save power.
It’s always a good idea to thoroughly double-check your connections before applying power.
Locate the battery snap connector. Connect and solder the red lead
to the positive-switch lug of the power jack.
RING LUG
SLEEVE LUG
TIP LUG
Input Jack
Connect and solder the black lead of the battery snap
connector to the input jack’s ring lug.
POSITIVE-SWITCH LUG
mounting tabs
