Mockett PCS88-90, Руководство пользователя

Страница: 11 / 14

8 PCS88-90 / PCS88-94 - Installing the PCS88-90 / PCS88-94
5.2 Inserting the PCS88-90 / PCS88-94 through the Cut-Out
Opening
To install the PCS88-90 / PCS88-94 , do the following:
1. Unscrew the power connector lock.
2. Connect the IEC power cord to the IEC socket.
3. Insert the power cord into the power connector lock and tighten the screw
(see Figure 2 , item 12) to secure the power cable.
4. Carefully insert the unit into the prepared opening.
5. Take the support clamps under the table and place them into the support
clamp late slits at the desired height (on both the front and rear sides of the
unit).
6. Make sure that the upper outer rim is situated parallel to the edge of the
table.
7. Insert the mounting screws through the holes in the mounting clamps.
Tighten the mounting butterfly nuts to secure the unit to the table surface
and then lock with the mounting butterfly screw.
5.3 Connecting the Cables
1. Connect the appropriate cables from underneath.
2. Secure the cables.
Do not keep the cord too tight or too loose.
Once you have connected the unit to the mains power and connected the proper
cables, you may use the unit.