Mocka Brooklyn Change Table страница 8 Скачать руководство пользователя

Страница: 8 / 8

Brooklyn Change Table

Assembly Instructions

Thank you for your purchase.

Please follow the instructions below for correct assembly.

mocka.co.nz | mocka.com.au

Attach the safety strap (W) to the top of the back side of the unit using

screw (Y). Tighten with a screwdriver.

Once assembled lift furniture into place, do not drag. Use a drill to create

a small hole lining up with the top of the safety strap (W). Fasten to wall

using wall anchor (X), washer (Z) and screw. Ensure the unit is balaced

and steady before use. You’re done, enjoy!

wall

screw

wall

anchor

wall

screw

Washer

Strap

Attach the safety strap (W) to the top of the back side of the unit using.

Содержание Brooklyn Change Table

Страница 2: ...llow the instructions below for correct assembly mocka co nz mocka com au 3 1 2 A A A x4 x4 B A x4 B B A A A A B B 3 A A 7 Tighten with a screwdriver Attach 4 x bolt A to panel 1 and 2 Insert 4 x locking nut B into panels 3 Insert 4 x bolt A into panels 3 and 7 Tighten with a screwdriver ...

Страница 4: ...u 5 8 8 7 3 B C C C C C C C C B B B B B x6 B Insert 6 x dowel C into panel 3 and 7 and 8 Attach panel 3 to panels 7 and 8 and secure with 6 x locking nuts B Tighten with a screwdriver 5 4 8 8 7 3 C C C C C B B B B B B x6 B Insert 6 x dowel C into panel 3 and 7 and 8 Attach panel 3 to panels 7 and 8 and secure with 6 x locking nuts B Tighten with a screwdriver ...

Страница 6: ... Drawers x2 16 9 9 Cx2 Cx2 Slot panel 16 down into grooves in the side and front panels Insert 2x dowels C into the end of both support braces 9 and peg into holes in front panel 15 Drawers x2 F 14 F F F Cx2 Cx2 x4 F Insert 2x dowels C into the other end of each support piece 17 Place back panel 14 into position on dowels and fasten into place using 4x screws F ...

Страница 7: ...tions below for correct assembly mocka co nz mocka com au Drawers x2 E H E E Finally attach rail hardware H to both left and right side of the drawer using screws E Repeat Steps 7 to 10 until all four drawers are fully assembled Now both drawers are made up slide them into rails in the change table unit x2 ...