79
/140
Installing The Wall Mount
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
2.6.2 Procedure
1.
Remove the camera mounting ring
: Separate the black
mounting ring from the camera housing. This ring is not
required when mounting the camera to the Wall Mount. If
the D25M was not in its original packaging, then it may be
necessary to remove the outer shell with the four Allen
screws beforehand.
2.
Separate the bottom plate from the Wall Mount:
The
bottom plate is used to hold the camera and is only
attached and screwed into place during a later step.
3.
Pass the camera cable up through the bottom of the
bottom plate:
Ensure the orientation is correct. The
spring clips should be on the underside of the bottom
plate.
4.
Snap the camera into place on the bottom plate:
Firmly push the camera into the Wall Mount. The plastic
spring clips will snap into place when the trapezoidal
elements on the rear of the camera housing exactly
match up with the corresponding openings on the
Wall Mount.
Содержание D25M
Страница 9: ...9 140 MOBOTIX AG Security Vision Systems Made in Germany www mobotix com sales mobotix com ...
Страница 137: ...137 140 Additional Notes MOBOTIX AG Security Vision Systems Made in Germany www mobotix com sales mobotix com Notes ...
Страница 138: ...138 140 D25M Camera Manual MOBOTIX AG Security Vision Systems Made in Germany www mobotix com sales mobotix com Notes ...
