Mobotix D25M, Руководство пользователя

Страница: 58 / 140

58
/140
D25M Camera Manual: Installation
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
2.2.2 Procedure For All D25M Cameras
1. Install and prepare
the network connection.
2. Drill the holes : Please use the enclosed screws and screw anchors whenever
possible. It is essential that you use the supplied drilling template to ensure the
precise alignment of holes for either the mounting ring of the D25M IT/Secure or
the camera base of the D25M Basic (fold-out at the end of this manual).
3.
Hollow out background surface
for the cable and connector or insert the cable
behind the suspended ceiling or cable duct.
4.
Connect
the pre-installed network cable of the camera to the installation cable
(adapter not included in delivery).
5. Attach the camera to the ceiling or wall (see sections below).
6.
Aim and adjust the
lens (see Section 3.3.1).
Caution
For safety reasons, only use the pre-installed MOBOTIX network cable that was
included in the delivery. Always ensure that the rubber plug of the network cable
reliably protects the outer shell from moisture entering the camera. All openings of
the camera housing need to be properly sealed. This is the only way to guarantee
that the camera remains weatherproof.
Notes
Network Connection Without Pre-Installed Cable
The network cable is fed through the ceiling directly above the camera. Make sure
the cable is completely sealed by the rubber gasket on the housing (do not bend the
cable!) When preparing the installation, ensure that at least 15 cm of cable length
(excluding the connector itself) remains inside the camera housing (similar to factory
preinstallation). This will ensure that you can turn and tilt the lens mount freely later on.
Surface-Mounted Socket
If a surface-mounted socket is used, the camera must be mounted using the out-
door Wall Mount. The camera cannot be mounted directly on top of protruding,
surface-mounted sockets.