BulletCamera MOBOTIX MOVE BC-4-IR-D
This guide is for quick installing and connecting the BulletCamera MOBOTIX MOVE BC-4-IR-D. You can find detailed
information on the installation and connections in the Camera Manual (PDF, available on www.mobotix.com >
Support > Download Center > Documentation > Manuals).
Installation Notices
• This camera must be installed by qualified personnel and the installation should conform to all local codes.
• This camera contains replaceable batteries. To prevent explosion risks, confirm the battery type before
replacement. Dispose of used batteries in accordance with the local regulations.
• To use an external power supply, please contact the camera manufacturer to confirm that the power supply uses
the same power specifications as the camera. The power supply must comply with the LPS requirements.
Installation
• Place the camera at the installation location. On the ceiling/wall, mark the
position of the two screw holes
1
of the camera.
• If the screw holes are blocked by the camera body, loosen the three screws
2
,
but do not detach it. Then rotate the camera body to reach the screw holes.
• At the center of the two marked holes, drill a 30 mm diameter (radius as 15 mm)
cable entry hole. Then drill a hole slightly smaller than the supplied plastic screw
anchor on each marked screw hole.
• Thread the All-in-One cable of the camera through the cable entry hole. Refer to
chapter Camera Cabling for cable connections.
• Match the two screw holes of the camera with the plastic screw anchors at the
installation location. Insert the plastic screw anchors into the two drilled holes,
and then fasten the camera with the supplied M4x31 self-tapping screws.
• Use a cross screwdriver to loosen the four screws
2
3
indicated in the right
figures but do not detach them. Rotate the camera and point the camera to a
desired direction. Lastly, tighten the four screws to secure the camera.
microSD Card Slot/Reset Button
microSD Card Slot
Insert the microSD card into the card slot to store videos and
snapshots. Do not remove the microSD card when the camera
is powered on.
NOTE: We do not recommend permanent recording on a
microSD card, as it may not be able to support long
term continuous data read/write. Please contact the
manufacturer of the microSD card for information
regarding the reliability and the life expectancy.
Reset Button
Press the reset button with a proper tool for at least 20 seconds to restore the system.
1
1
2
3
2
2
