MOBIUS MBX BUCKER USER GUIDE
19
18
© 2 0 2 0 E T E R O S T E C H N O L O G I E S I N C . A L L R I G H T S R E S E R V E D . | M O B I U S T R I M M E R . C O M
CLEANING
With the exception of the motor, gearbox and electrical enclosure, the MBX BUCKER can be washed,
cleaned, and wiped down with normal detergents, degreasers, and disinfectants.
The front die plate and rear chipper cover may be removed to facilitate cleaning. The inside of the
MBX BUCKER can be washed and wiped as needed.
The exterior of the MBX BUCKER should never be hosed or sprayed. Evidence of water near the motor,
conduit, electrical panel, or gearbox could void the machine warranty.
STEP-BY-STEP INSTRUCTIONS
1.
Shut down the machine, disconnect all power sources and lock out (if applicable). Ensure that
the Bucker is always de-energized when working within.
2. Remove the front dieplate to expose the rolls.
3. Remove the rear Lexan window to expose the chipper assembly.
4. Using hot water, spray or pressure wash the interior of the machine. Use caution not to
pressure wash the rolls directly, as the high pressure jet may damage the rolls.
NOTE
: The electrical panel and rear of the Bucker should never be hosed or sprayed directly.
Use caution not to spray near the motors or into the vents in the rear of the Bucker.
5. Generously apply a detergent to the dieplate, Lexan window, rolls, chipper assembly, stock
chute and all other internal components. We recommend Super Clean and Resin8 Xtra.
6. Allow the detergent to soak in up to 20 minutes and break down the resinous plant material.
Brush any areas that are heavily soiled using a stiff plastic bristle brush.
7. Rinse the entire interior of the machine using hot water spray or pressure wash. Use caution not
to pressure wash the rolls directly.
8. Inspect for any remaining plant material and repeat detergent, scrub and rinse as necessary.
9. Reinstall the front dieplate and rear lexan cover, power up the machine and operate rolls for a
few seconds.
10. Repeat steps 1 - 8 to ensure no additional plant material is remaining.
11.
Sanitize rolls or other internal components if desired using
or ISO.
12. Wipe the exterior of the Bucker using a detergent to remove any plant material.
13.
Sanitize the dieplate, Lexan cover and exterior components if desired using
or ISO.
14.
Complete one final inspection, then reinstall the dieplate and Lexan cover to prepare for use.
DO NOT SPRAY
MAINTENANCE
The MBX BUCKER is largely maintenance-free.
We recommend that the front die plate be removed regularly to confirm stems are not building up
inside the unit.
We recommend removing the front die plate and rear cover daily to ensure all debris are removed
from the inside of the machine.
We recommend removing the front die plate and rear cover from the main machine to:
1. Ensure all debris are removed from the inside of the machine
2. Verify the oil level in each gearbox. Add 2-4 pumps of FDA-approved white lithium grease to
each bearing.
HOURLY INSPECTION
DAILY INSPECTION
WEEKLY INSPECTION
