Automatic Power Off from Standby mode
If the camera is in standby mode you must take a picture(s) or start a video recording
within *30 seconds. The camera will automatically turn off after *30 seconds of no
activity.
*This value can be set using the setup program. Automatic Power Off can also
disabled.
When the special A/V cable is connected, automatic power-off will be disabled. This
prevents signal loss during fpv use when the standby time times out.
Turn on Camera
Power-On can be configured as "fast" or "delayed". In fast mode, the camera will turn
on immediately when the Power Button is pressed. In delayed mode, press and hold
the Power Button for 3-4 seconds until the Red LED turns on. The camera is ready
for use once the Yellow LED turns on. .
•
If the camera has been configured with "Auto Power-On Record" set to ON,
the camera will automatically begin recording in Mode 1 as soon as the power
button is pressed or external power is connected. If the recording LED has
been disabled, the yellow (or blue) LED will slowly flash 3 times and then turn
off, indicating that recording has started. Otherwise the yellow LED will slowly
flash at 2 second intervals indicating that the camera is recording.
•
If the camera has been configured with "Auto Record" set to OFF (default
setting), the camera will switch to Video Mode 1 (yellow LED) and remain in
standby mode until a button is pressed or Auto-Power-Off times out.
Turn off Camera
Power-Off can be configured as "fast" or "delayed". In fast mode, the camera will turn
off almost immediately after the Power Button is pressed. In delayed mode, press
and hold the Power Button for 3-4 seconds until the Red LED flashes. The camera
will then turn off.
Switching between modes
The camera can be switched between the different modes by pressing the Mode
button. Each button click advances the camera to the next mode. Video Mode1 -
Video Mode2 - Photo Mode - Video Mode1 etc.
Recording Video Mode 1 or 2 (yellow or blue LED)
Start video recording.
•
Briefly press the shutter button.
•
►
If the recording LED has been disabled, the yellow or blue LED will slowly
blink 3 times and then turn off, indicating that recording has started.
•
►
If the recording LED has been enabled, the yellow or blue LED will slowly
flash at 2 second intervals indicating that the camera is recording.
Stop video recording.
•
Briefly press the shutter button. The camera will return to the standby mode
from which the video was started.
