Mobius Bionics LUKE Arm, Руководство пользователя

Страница: 100 / 177

120
Use or Disclosure of Data Contained on this Page is Subject to the Copyright Restrictions on the Inside Title Page of this Document -- Rev. 1.5
Chapter 8: Installing IMUs
Installing the IMU/Shoe Clip on the Client’s Shoe
To install the shoe clip on client’s shoe, see Figure 66 and perform the following
steps:
1. Orient the shoe clip so that the open end of the clip is facing towards the client’s
toes.
2. Slide the shoe clip under the laces of the shoe.
When installing the shoe clip to the shoe, please ensure the following:
• The shoe clip passes through at least two of the shoe’s laces to ensure the
clip is secure and stable.
• The Front Arrow label on the bottom of the IMU is facing towards the
client’s toes. See
Figure 65 .
3. Tighten the laces to secure the IMU and shoe clip to the shoe.
4.
If the client has not already done so, have them put on the shoe.
Figure 66. Attaching the IMU/Shoe Clip to the Client’s Shoe
• Note that the shoe clip can be installed onto the shoe with the shoe on or
off the client’s foot.
• Once the shoe clip is installed, the shoe clip can remain on the shoe.
• If the IMU is in the clip, make sure to attach the clip and IMU to the
correct foot per the client's configuration.
Open End of Shoe Clip
NOTE: IMU is Shown Attached
to Shoe Clip.