Mobility Research LiteGait 300P Deluxe, Руководство оператора и сервисное руководство

Страница: 11 / 31

11
www.LiteGait.com
1-800-332-9255
12) Locate the hand switch and
slightly raise the actuator to al-
low enough access to remove
actuator from pallet.
13.) Locate bolts holding actua-
tor to pallet. Undo bolts with ½
inch socket or wrench, loosen
actuator from pallet with one
person holding the actuator
steady while loose.
14.) Lower handlebar base on
actuator and tighten knobs be-
fore lifting. Ensure base is ready
for positioning actuator. Using
two people lift actuator from
pallet to base.
15.) Orient the actuator on the
base (the yoke arms and handle-
bars point in the same direc-
tion as the base legs). Line up
the holes for bolts to be in-
serted.
11.) Set base over pallet as pic-
tured with actuator next to
base.
16.) Insert bolts, hand tighten
bolts (ensure one person holds
actuator steady until secure).
Tighten bolts using 5/16 inch
Allen wrench until snug (do not
to over tighten).
18.) Remove remaining shrink
wrap from handle bars.
17.) Verify operation by moving
actuator up/down by pressing
the arrows on the hand switch.
If hand switch fails to operate
the actuator, check connections
at top of the actuator.
CAUTION: DO NOT over tighten the
bolts.
CAUTION: DO NOT USE UTILITY
KNIFE TO REMOVE SHRINK WRAP
19.) Remove remaining shrink
wrap from yoke.
20.) Remove remaining shrink
wrap from base.
21.) Verify performance of each
locking and directional casters.
Call Mobility Research Service &
Parts Department at 1-800-332-
9255 Extension 7104 for assis-
tance during this assembly.