2
3
Introduction
Congratulations on your purchase of a quality MobileVision Rearview Security Camera. This
camera has been designed to provide you with a product that is technologically superior and
provide years of trouble free operation.
The information enclosed provides a quick reference of the operations and maintenance of your
new Rearview Security Camera.
This product must be installed and used in accordance with this manual. Any alterations to this
product that enables it to be used in any way other than intended or designed could distract the
driver and result in an accident causing injury or death. Magnadyne Corporation disclaims any
and all liability that may result from failure to install and operate in any other manner in which
this was intended.
Camera Features
1
2
1. +12 Volts
4. Video
2. N/A
5. Ground
3. Audio
3
4
6
7
5
1. Built-In Microphone
2. Adjustable Viewing Angle
3. Aluminum Die-Cast Waterproof Housing
4. Removable Wind Deflector
5. Illumination LEDs
6. 1/3” Color CMOS Camera Lens
7. Photo Sensor
Specifications
Image Sensor:
1/3” Color CMOS
Board Lens:
2.8 mm
Resolution:
500 TV Lines
S/N Ratio:
Better than 48dB
Sync System:
Internal Synchronization
Minimum Illumination:
0.1 Lux (day), O Lux (IR LED On)
Video Output:
1.0Vp-p 75 ohm
IR Project Distance:
15 Meters
Water Resistance:
IP69K
Power Consumption:
Max 100 mA
Camera & Bracket Weight:
350g
Operating Temperature:
-20°C ~ 70°C
5/8”
Pass-Through
Hole
Mounting
Screws and
Washers
1. Select a position to mount the camera
that is free of obstructions and mov-
ing parts and has a proper viewing
angle of the area behind the vehicle.
2. Remove the mounting bracket from
the camera and use it as a template to
drill mounting holes and a 5/8” cable
pass-through hole.
3. Position the camera mounting bracket
and align with pre-drilled holes then
secure bracket with screws.
4. Insert the camera cable into the pass-
through hole and secure the camera
to the mounting bracket. Use silicone
to seal the pass-through hole.
Mounting the Camera
Troubleshooting
Symptoms
Solutions
Cloudy Image
No Power / Image
No Sound
Upside Down Image
Unstable Image
• Clean Dirty Camera Lens
• Check Power Connections
• Check Power Connections
• Check Microphone for Debris
• Check Camera Mounting
• Check Mounting Hardware
• Check Power Connections
Only qualified personnel should remove the cover or service this unit. The warranty will become invalid
if factory security seal is broken.
Maintenance
Although this Rearview Security Camera requires little care, you can still maintain its condi-
tion and performance by following these steps:
• Occasionally clean the camera lens with damp soft cloth.
Should you experience any problem with the camera please refer to the troubleshooting guide
below prior to returning your camera for repair.
Note: The user should not attempt to service the unit beyond that described in the operating
instructions. All other servicing should be referred to qualified personnel.
Warning
Backing Up Your Vehicle
The product is intended to assist in safe driving and allows the driver to have a broader field
of vision during backup. You, as the driver, are solely responsible for the safe operation of
your vehicle and the safety of your passengers and pedestrians, and abiding all state and
local traffic regulations. Do not use any features of this system to the extent it distracts you
from safe driving. Your first priority while driving should always be the safe operation of
your vehicle. Magnadyne will not accept any responsibility whatsoever for accidents and/or
injuries resulting from failure to observe these precautions or safety instructions.
