21
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions (1)this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
The SAR limit of USA (FCC) is 1.6 W/kg veraged over one gram of tissue. Device types Rugged Tablet
(EM-I16H) (FCC ID:
2A37Q-EM-I16H) has also been tested against this SAR limit. The highest SAR
value reported under this standard during product certification for use at the body is 0.663W/kg and
Simultaneous Transmission is 0.883W/kg. This device was tested for typical body-worn operations with
the back of the handset kept 0mm from the body. To maintain compliance with FCC RF exposure
requirements, use accessories that maintain a 0mm separation distance between the user's body and
the back of the handset. The use of belt clips, holsters and similar accessories should not contain
metallic components in its assembly.The use of accessories that do not satisfy these requirements may
not comply with FCC RF exposure requirements, and should be avoided.
