Health Check
•
Press buttons ‘MEM/SET’ and ‘MODE’ together for 2 seconds to enter the
countdown. Use the ‘MODE’ button to toggle between 15 minutes, 30
minutes or 45 minutes or OFF.
•
Press the ‘MEM/SET’ button when the desired time is on screen to start
counting down. When the countdown is active and running in the
background the “ ” sign will flash on screen.
•
When the countdown begins, the user can press ‘MEM/SET’ and ‘MODE’
button together for 2 seconds to display the remaining time, then press
‘SCAN’ button to return to waiting mode or press ‘MEM/SET’ button to cancel
the countdown.
•
When the countdown is zero. Health check “ ” symbol will display on LCD and
the unit will ‘BEEP’ to remind the user. To stop the notification’s and return to
the home menu press any button.
Memory Function
•
This unit can recall up to 9 prior measurements stored in memory.
•
Turn on thermometer, press the ‘MEM’ button once, then press it again to
show the last measurement.
•
The symbols for ‘EAR’ or ‘FOREHEAD’ will appear with each measurement
stored in memory to indicate whether a person’s forehead or ear
temperature was taken.
•
Each press of the same button recalls a previous measurement.
Troubleshooting
Problem
Checklist
Countermeasure
No response/automatic
reset when pulling out
plastic insulator tab.
Batteries are low or dead
Batteries installed in
wrong polarity?
Poor battery contact?
Change to new
batteries
Remove batteries and
reinsert batteries
correctly
Measured temperature
is lower than
89.6°F/32.0°F or higher
than 109°F/42.9°C
Follow steps in user
manual for correct
measurements.
Check the device is in
the correct operating
mode.
These Error messages
indicate a problem with
the hardware.
Contact Mobi
Technologies, Inc. via
contacting information
at the end of this
manual.
Operating Temperature is
out of the range
Use the thermometer in
the range of operating
conditions
The sensor temperature
has not been stabilized
Wait 10 seconds and
take a measurement
again.
The measurement is
not accurate or there is
doubt of measurement
results.
Check to see if the
infrared sensor is clean or
not.
Clean the infrared
sensor with cotton swab
according to the user
manual.
Determine whether your
measuring method is
correct or not.
Please review the user
manual and ensure you
are operating the
thermometer correctly.
Assess whether you have
allowed the thermometer
and the patient to
become stabilized in the
room for 30 minutes.
Please ensure the
thermometer and
patient remain in the
location for at least 30
minutes before
recording a
temperature.
Are you using the
thermometer indoors or
outdoors.
Always do the
measurements indoors.
Determine if you might
have held the
thermometer in your
hand too long which may
affect its accuracy.
Place the thermometer
in the room where the
measurement is due to
be taken, let it stabilize
for 30 minutes before
use.
Check to see if the Low
Battery icon is showing on
the LCD screen.
Immediately replace the
batteries with new ones.
Product Safety & Warnings
WARNING:
WARNING:
WARNING:
WARNING:
WARNING:
WARNING:
This product was designed to measure human body
temperature on the forehead, do not use this for any other
purpose.
Do not use this thermometer if it has been malfunctioning or it
has been damaged.
This product is not waterproof. Do not use this product under
any wet conditions and do not immerse in any liquid or water.
This product should not be left alone with children or pets with
not in use by an adult.
Do not store the thermometer in extreme temperatures below
(-4°F / -20°C) or over (131°F/ 55°C).
Do not use the product in a wet ear canal after swimming or
bathing. It is possible to damage the ear canal.
Equipment Symbols
Warning
Compliance with WEEE Standard
Non-Sterile
Packaging
DO NO THROW AWAY intended
for multiple use
Refer to
Operating
Instructions
Operating atmospheric pressure
Operating
Temperature
Serial number
Operating
Humidity
Recyclable
Manufacturer
This device compiles with Part 15
of FCC (federal communications
commission) rules.
IP22: The first number 2: Protected against solid foreign objects to
12.5mm Φ and greater. The second number: Protected against
vertically falling water drops, when enclosure titled up to 15°.
Limited Product Warranty
MOBI® warrants its products to be free from defects in material and
workmanship for period of (1 Year) from the date of purchase. Should the
product prove to be defective at any time during the warranty period, we would
either replace or repair the product at our option without charge. After the
warranty period, a service charge will apply for replacement of parts and labor
costs. To obtain warranty service, you must return the product complete with its
original parts & accessories along with a copy of the original purchase, gift or
registry receipt to us. This warranty does not cover damage caused by any
tampering, accident, misuse, abuse, improper maintenance, unauthorized
modification, or connection to an improper power supply. There will be a charge
for repair caused for such damage. This warranty excludes all incidental or
consequential damages and any liability other than stated above.
Questions?
Please visit:
Email:
Note: For Detailed Instructional Manual please follow this link:
http://www.getmobi.com/users-manuals
© 2021 MOBI Technologies, Inc.
All Rights Reserved
