4.
Install two Bolt Sleeves (10) into upside down Base (7)
a
nd
then position two Bolts (12) through Bolt Plate
(11)
and
into
Bolt Sleeves (10). Position Base (7)
over Column
Assembly (2) and thread bolts into
bottom of Column
Assembly (2) and tighten using
16mm wrench. See Fig. 6.
5.
Turn the table upright and stand on casters.
6.
CAUTION:
This step must be completed last to prevent
damage to the spring loaded mechanism. Remove the
Black Screw (13) in the Column Assembly
(2) collar labeled “Remove for Assembly” and replace it
with the Chrome Screw (14) contained in hardware
package. Do not remove Chrome Screw labeled “Do
Not Remove”. See Fig. 7 and Fig. 8.
FIG. 7
Remove 13
FIG. 8
Insert 14
WARNING
FOR SAFETY – DO NOT REMOVE BLACK SCREW (13) ON
COL-UMN ASSEMBLY (2) UNTIL THE TABLE IS FULLY
ASSEMBLED AND STANDING IN UPRIGHT POSITION. AFTER
REMOVING BLACK SCREW, REPLACE WITH CHROME SCREW
(14) INCLUDED IN HARDWARE PACKAGE.
THE BOTTOM CHROME SCREW WITH THE “DO NOT REMOVE”
LABEL SHOULD NEVER BE REMOVED AS IT WILL DAMAGE
THE UNIT AND VOID YOUR WARRANTY.
12
11
2
FIG. 6
10
1
7
connects to Column Assembly (2). Install two
Non-Locking Casters (9) into base opposite Column
Assembly (2). See Fig. 5.
Tilt-Top Overbed Table
: MHFTAB
Assembly Instructions
Mounting Tube (5) on table top. See Fig. 4.
3
. Install two Casters With Lock (8) into Base (7) which
2
. Insert tube on Column Assembly through
upside down on flat surface with Mounting Tube (5)
facing upward. See Fig. 2.
1.
Remove contents from packaging and lay top board
