Mobatime 122031, Монтаж и инструкция по эксплуатации

Страница: 52 / 124

© MOBATIME 52 / 124 801214.10
6.5.22 SNMP traps
For a description of SNMP functionality, see also chapter “9 SNMP“. Traps are also
designated as notifications (from SNMP V2)
DTS 4160.grandmaster Moser-Baer AG
====================================
SNMP-TRAP CONFIGURATION
1 Trap mode off
2 Alarmmask for trap ff ff ff ff ff ff ff ff
3 Trap community string trapmobatime
4 Configuration of destination 1
5 Configuration of destination 2
6 Time periode for alive message 0
98 Return and save
99 Return and discard changes
Enter desired menu number>
Path: 2 Configuration

3 Alarms

3 Traps
1. Trap mode on or off (applies to alarm and alive traps)
2. Alarm mask for SNMP trap messages (see chapter "6.5.20 Alarm mask")
Changes are first stored or reset on the overlying menu page “SNMP TRAP
CONFIGURATION“.
3. Trap community string (group membership for traps).
Standard: trapmobatime .
4. Configuration of the receiving system (trap sink) 1
5. Configuration of the receiving system (trap sink) 2
6. Time period for alive messages in seconds. 0 = no alive traps are sent
Range: 1-7'200sec
Notice:
General settings for SNMP can be found in menu ’2. Configuration’

’7. SNMP’. See also chapter "6.5.29 SNMP").
Notice:
Configuration of a gateway is required for sending SNMP traps (see
chapter 6.5.24 Network). This can be set via DHCP or manually.
Notice:
Each configuration change leads to a restart of the DTS SNMP Agent.