Hot Water Dispenser
- English manual
6
EN
HOW TO USE
Before first use: If use the appliance for first time, please clean up the
water tank before use. Always unplug from the plug socket and allow
to cool down before cleaning,the surface of the water tank is wiped
over with damp cloth and polished with a soft dry cloth, fill in water
to clean, plug in and start operation,let the water flowing until tank is
empty and repeat the same steps for several times, then refill the proper
clean water to be ready for operation.
Tips: First use of the appliance: Please operate the appliance about 10
seconds by setting the temperature of 000 and volume 000, after that
run by setting the temperature 100C and volume 000 for one minute
until the detection of boiling point is finished. The appliance is ready for
use - set the Temp and Volume to desired settings.
1. Fill in water:
Open the lid, fill water in tank till the max level and then close the lid.
Note: the water level must be less the Max level and over the Min level.
You can select two methods as per the following
Tips: Suggest to use purge water in the appliance.
2. Obtain desired water:
Make sure the plug is connected to the proper wall outlet and fill water
in tank till max level. Place your cup on the removable water tray,
make sure it aligns with the spout. First press the Lock button about 3-5
seconds to open by finger, Temp. and Volume setting indicator lights
up, and then press the Temp. button to choose your desired temperature
and press the Volume button to choose your desired volume, Last
press the Start/Stop button to operate the appliance, about 5-10s, the
desired water will flow out continuously from water spout , when you
obtain desired water, press the Start/Stop button, the appliance stop
working at once. If you want to obtain water again, only repeat the
above procedure. When lack of water,the E7 symbol show on display
to remind filling water in tank.
