mLogic Desktop SAS LTO Series, Руководство пользователя

Страница: 7 / 19

Powering on Desktop SAS LTO
6
1) Press the power button located on the back of the unit to the “_” position
2) Wait for the Ready Light on front of Desktop SAS LTO to illuminate steady green
3) Power on your computer
Note: When initially powered on, Desktop SAS LTO will perform a hardware Power On Self-Test (POST).
The POST checks to make sure that the LTO drive is functioning properly. During POST, the Single
Character Display (SCD) flashes several segmented characters.
Each character represents a test performed during POST. When POST finishes, the SCD will momentarily
light all segmented characters and will then go blank. POST takes approximately 12 seconds.
Note: If Desktop SAS LTO is powered on with a tape cartridge installed, the system will perform a much more
intensive POST while the system verifies the integrity of the data on the tape.
Never leave a tape in Desktop SAS LTO with the unit powered off!
Note: Never remove power from Desktop SAS LTO during read, write, load and unload activities.