MLis MLB-G3001, Руководство пользователя

Страница: 36 / 57

MLB-G3001 Terminal User Guide 36 Rev 1.1
5.7 Command Explanation
5.7.1 AT^SICS Internet Connection Setup Profile
AT^SICS= <conProfileId> , <conParmTag> , <conParmValue>
< conProfileId >
(num)
0...5 Internet connection profile identifier.
The <conProfileId> identifies all parameters of a connection profile, and when a
service profile is created with AT^SISS the <conProfileId> needs to be set as
"conId" value of the AT^SISS parameter <srvParmTag>.
< conParmTag > (str)
Internet connection parameter
"conType" Type of Internet connection.
For supported values of <conParmValue> refer to <conParmValue-con-Type>.
"user" User name string: maximum 31 characters (where "" is default).
"passwd" Password string: maximum 31 characters (where ***** is default).
"apn" Access point name string value: maximum 99 characters (where "" is default).
"inactTO" Inactivity timeout value in seconds: 0 ...
2
16
-1, default = 20
Number of seconds the bearer remains open although the service no longer
needs the bearer connection.
Setting the value to 0 does not deactivate the timer. If the value is set to 0, the
bearer is closed immediately after the service no longer needs the connection.
Short timeout may result in problems when using the <eodFlag> (set in the last
AT^SISW command to terminate an upload data stream). It is possible that the
bearer will get closed before the flag will be transmitted. As result the server will
not receive the flag. Considering this avoid setting the timeout value below 3
seconds when using the <eodFlag>.
"dns1" Primary DNS server address (IP address in dotted-four-byte format).
This value determines whether to use the DNS server addresses dynamically
assigned by the network or a specific DNS server address given by the user.
"dns1" = "0.0.0.0" (default) means that the CSD or GPRS connection profile
uses dynamic DNS assignment. Any other address means that the Primary
DNS is manually set.