1. Center and attach the Cross Frame (#1) to the bottom of your stock using (4)
#15 Round Head Screws. Screwing the Cross Frame (#1) is the most effective
way to attach it to your stock.
2. Measuring from the center of the Cross Frame (#1), make a pencil mark at the
distance of the radius ( half of your diameter ) you wish to cut.
3. Slide (1) T-Bar Sliding Rod Mount (#3) into one of the slots on the Cross
Frame (#1). Slide the T-Bar Sliding Rod Mount (#3) to center of the Cross
Frame (#1) and secure it in place using the Knurled Head Cap Screws (#10).
4. Slide the Steel Rod (#4/#5) through the hole in the T-Bar Sliding Rod Mount
(#3).
5. If you are making an external cut, adjust the distance of the Steel Rod (#4/#5)
so the edge of the router bit being used is on the outside of the pencil mark
made in step 2. If you are making an internal cut, adjust the distance of the
Steel Rod (#4/#5) so the edge of the router bit being used is on the inside of
the pencil mark made in step 2.
Copyright 2007 MLCS ltd.
Page 4
