LEDAMP
These instructions should be read carefully and retained after installation by the end user for future reference and
maintenance.
These instructions should be used to aid installation of the following product:
LEDAMP
SAFETY
•
Installation of this product should only be carried out by a qualified electrician or competent person to the
latest Building and current IEE Wiring Regulations (BS7671)
•
Please isolate mains prior to installation/maintenance
•
Check the total load on the circuit (including when this amplifier and LED load is fitted) does not exceed the
rating of the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress of Protection) rating of this product when deciding the location for installation
•
This unit is rated at IP20
•
This product is Class II and does not require an earth
•
This product is a subsidiary of LED lighting control system products and should be used in conjunction with
the RGB controller, RGB strip and power supply to enhance the system load ability
INSTALLATION
•
Provide power to the required point of installation
•
Connect the Amplifier to the circuit using the
CONDC or wiring directly into + / - ensuring the correct polarity is
observed (see Fig 1)
Fig 1
2
These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following product:
LEDAMP
GENERAL INSTRUCTIONS
SAFETY
INSTALLATION
• Installation of this product should only be carried out by a qualified electrician or competent
person to the latest Building and current IEE Wiring Regulations (BS7671)
• Please isolate mains prior to installation/maintenance
• Check the total load on the circuit (including when this amplifier and LED load is fitted) does
not exceed the rating of the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress of Protection) rating of this product when deciding the location for
installation
• This unit is rated at IP20
• This product is Class III
• This product is a subsidiary of LED lighting control system products and should be used in
conjunction with Knightsbridge LED Flex and power supply to enhance the system load ability
• Provide power to the required point of installation
• Connect the Amplifier to the circuit, via the 12V / 24V DC LED driver, using the CONDC or wiring
directly into + / - ensuring the correct polarity is observed (see Fig 1)
Fig 1