INSTALLATION
Note - If this product is being used in conjunction with an external PIR or sensor, please
confirm with the manufacturer of the sensors that they are compatible with LED luminaires.
•
Provide power to the required point of installation
•
Cut a suitable hole in the mounting surface as per the cut-out details (see Fig. 1) ensuring
not to infringe with any joists, gas/water pipes or electrical cables
Fig. 1
RW6 Series
These instructions should be read carefully and retained after installation by the end user for future
reference and maintenance.
These instructions should be used to aid installation of the following products:
RW6WW / RW6CW / RW6CCT
SAFETY
•
Installation of this luminaire should only be carried out by a qualified electrician or
competent person to the latest Building and current IEE Wiring Regulations (BS7671)
•
Please isolate mains prior to installation/maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not
exceed the rating of the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress of Protection) rating of this luminaire when deciding the
location for installation
•
We recommend a 50mm spacing around and above the fitting for air dissipation
•
This product is Class I and must be earthed
•
This product is dimmable with most trailing edge dimmers
•
This product is IP65 rated
INSTALLATION
Note:
If this luminaire is being used in conjunction with external PIR or sensors, please confirm with
the manufacturer of the sensors that they are compatible with LED luminaires.
•
Provide power to the required point of installation. Suitable IP rated junction boxes should
be used where required
•
Cut a suitable hole in the ceiling as per the cut-out details in Fig 1 ensuring that it does not
infringe with electrical cables, water/gas pipes or ceiling joists
Fig 1
72mm
