• Feed the cables through the compression glands on the bottom of the sensor
• Connect the sensor to the mains supply ensuring the correct polarity is observed (see Fig. 1): L - Live
(brown), N - Neutral (blue)
• Connect the load to the sensor ensuring the correct polarity is observed (see Fig. 1): L - Live (brown),
N - Neutral (blue)
INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid the installation of the following product:
OSPCKIT
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this product is fitted) does not exceed the rating of
the circuit cable, fuse, or circuit breaker
•
Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
•
Do not overload this accessory or subject it to conditions outside its rating
•
This product is Class II double insulated
•
This product is IP66 rated
INSTALLATION
•
Provide power to the required point of installation (refer to BS7671 for correct cabling methods).
Suitable IP rated junction boxes should be used where required
•
The power source connections should be local and accessible via a suitable IP rated enclosure
•
Round cable should be used for the mains supply. The use of flat cable will cause water ingress to the
fitting
•
Using the mounting bracket as a template, mark the location for, and drill the fixing holes ensuring not
to infringe with any gas/water pipes or electrical cables
•
Fix the bracket to a suitable solid surface using the screws provided
•
Unscrew the three screws on the bottom of the sensor and remove the plastic cover
•
Feed the cables through the compression glands on the bottom of the sensor
•
Connect the sensor to the mains supply ensuring the correct polarity is observed (see Fig. 1): L - Live
(brown), N - Neutral (blue)
•
Connect the load to the sensor ensuring the correct polarity is observed (see Fig. 1): L - Live (brown),
N - Neutral (blue)
Fig. 1
•
Adjust the lux level
•
Reattach the plastic cover and tighten the compression glands
•
Slide the sensor onto the mounting bracket
•
Switch on and check for correct operation
Fig. 1
• Adjust the lux level
• Reattach the plastic cover and tighten the compression glands
• Slide the sensor onto the mounting bracket
• Switch on and check for correct operation
Содержание OSPCKIT
Страница 1: ...INSTALLATION MAINTENANCE MANUAL OSPCKIT ...
