WARNING
This luminaire must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed.
This product is not suitable for installation in or near a coastal or marine environment.
•Feed the mains cable through the rubber grommet to retain IP rating, and secure the backplate to the surface
•
Connect the luminaire to the mains supply ensuring the correct polarity is observed (see Fig. 1):
L – Live (brown), N – Neutral (blue)
INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following products:
LWR2G / LWR2W / LWR4G / LWR4W / LWS2G / LWS2W / LWS4G / LWS4W
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
•
This product is Class II double insulated
•
This product is IP44 rated
INSTALLATION
Note - If this product is being used in conjunction with an external PIR or sensor, please confirm with the
manufacturer of the sensors that they are compatible with LED luminaires.
•
Provide power to the required point of installation (refer to BS7671 for correct cabling methods).
Suitable IP rated junction boxes should be used where required
•
Remove the mounting bracket from the luminaire with the aid of the Allen key supplied
•
Using the mounting bracket as a template, mark the location for, and drill the fixing holes ensuring not
to infringe with any gas/water pipes or electrical cables
•
Remove the backplate from the luminaire to access the PCB and mains terminals
•
Feed the mains cable through the rubber grommet to retain IP rating, and secure the backplate to the
surface
•
Connect the luminaire to the mains supply ensuring the correct polarity is observed (see Fig. 1):
L
–
Live (brown), N
–
Neutral (blue)
Fig. 1
•
Replace the backplate ensuring the gasket is in place and not damaged
•
Secure the luminaire to the mounting bracket
•
Switch on and check for correct operation
WARNING
This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance
testing. Irreparable damage will occur if this instruction is not followed.
This product is not suitable for installation in or near a coastal or marine environment.
GENERAL
This product contains a light source of energy efficiency class G to Regulation (EU) No 2019/2015.
This product contains an LED light source and a control gear which can be replaced by a professional.
Fig. 1
•
Replace the backplate ensuring the gasket is in place and not damaged
•
Secure the luminaire to the mounting bracket
•
Switch on and check for correct operation
