• Connect the supply cable ensuring the correct polarity is observed: L - Live (brown),
E - Earth (green/yellow), N - Neutral (blue). Please be aware that undue pulling or
rotating of the termination block will cause damage to the fitting
• Tighten the compression gland and sealing nut ensuring a tight seal is made. Do not
overtighten
• Tilt the fitting to the desired angle and tighten the nuts on the side
• Switch on and check for correct operation
Fig. 2
•
Unscrew the main body of the compression gland from the fitting, ensuring that the hexagonal lock ring
is not dislodged (see Fig. 2)
•
Remove the protective insert from the compression gland, leaving the rubber gasket in place (see Fig.
2), and pass the supply cable through the compression gland
•
Prepare the supply cable as shown by stripping back the outer sheath and basic insulation to the
correct length (see Fig. 3)
Fig. 3
•
Connect the supply cable ensuring the correct polarity is observed: L - Live (brown), E - Earth
(green/yellow), N - Neutral (blue). Please be aware that undue pulling or rotating of the termination
block will cause damage to the fitting
•
Tighten the compression gland and sealing nut ensuring a tight seal is made. Do not overtighten
•
Tilt the fitting to the desired angle and tighten the nuts on the side
•
Switch on and check for correct operation
PIR / Microwave Sensor Accessory
•
Isolate the mains supply to the fitting
•
Remove the capping nut, and using plyers pull out the protective insert from the fitting (see Fig. 4)
Fig. 3
