INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference and
maintenance.
These instructions should be used to aid installation of the following product:
EASPK1xx
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of the
circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
•
This product is Class II double insulated
•
This product is IP65 rated
INSTALLATION
•
Provide power to the required point of installation (refer to BS7671 for correct cabling methods). Suitable
IP rated junction boxes should be used where required
•
The power source connections should be local and accessible via a suitable IP rated enclosure
•
Choose a position for the luminaire ensuring the ground is suitable to firmly hold the spike and luminaire in
position. Check the ground is not liable to flooding and the spike does not infringe with any underground
pipes or cables
•
The body of the product should not rest directly on the ground
•
The pre-installed cable supplied is for above-ground use only. Cables that are to be routed within walls or
below ground must be protected by means of suitable conduit or trunking (see Fig. 1)
Fig. 1
•
Connect the luminaire to the mains supply ensuring the correct polarity is observed: Live (brown),
Neutral (blue)
•
Unscrew the bezel, insert a suitable LED lamp (5W max.) and carefully replace the bezel ensuring that the
seal is in place and not damaged
•
Switch on and check for correct operation
GENERAL
Clean the external surfaces with a damp cloth using a mild solution of detergent and warm water only, do not use
aggressive cleaning products or solvents which may damage the product.
Do not use any source of high-pressure washers to maintain or clean this luminaire.
This product is dimmable dependent on lamp type.
The external supply cable of this luminaire cannot be replaced; if the cable is damaged, the luminaire should be
destroyed
This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities for
where facilities exist.
WARRANTY
This product has a warranty of 3 years from date of purchase. Failure to install this product in accordance with the
current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will invalidate
INSTALLATION
• Provide power to the required point of installation (refer to BS7671 for correct cabling
methods). Suitable IP rated junction boxes should be used where required
• The power source connections should be local and accessible via a suitable IP rated
enclosure
• Choose a position for the luminaire ensuring the ground is suitable to firmly hold the
spike and luminaire in position. Check the ground is not liable to flooding and the spike
does not infringe with any underground pipes or cables
• The body of the product should not rest directly on the ground
• The pre-installed cable supplied is for above-ground use only. Cables that are to be
routed within walls or below ground must be protected by means of suitable conduit or
trunking (see Fig. 1)
Fig. 1
Содержание EASPK1 Series
Страница 1: ...INSTALLATION MAINTENANCE MANUAL EASPK1xx...
