MKT V-22/HP-380T4, Руководство по эксплуатации, техническому обслуживанию и каталог запасных частей

Страница: 22 / 73

VII. MAINTENANCE AND SERVICE INSTRUCTIONS (CONTINUED)
1. WARNING: DO NOT START THE POWER UNIT IF THE CLAMP PUMP
HAS BEEN INOPERABLE FOR A LONG PERIOD OF TIME WITHOUT
FIRST CHECKING TO BE SURE THAT THE PUMP IS PRIMED (I.E.,
THE PUMP CASE FULL OF OIL). THIS WILL PREVENT THE
STARTING OF THE PUMP WITHOUT LUBRICATION WHICH CAN
CAUSE PUMP DAMAGE. TO CHECK THE CLAMP PUMP REMOVE
THE DRAIN HOSE AND VISUALLY DETERMINE IF THE CASE IS
FULL OF OIL. IF OIL MUST BE ADDED TO THE PUMP FOR
PRIMING, EXTREME CARE MUST BE TAKEN WITH THE
CLEANLINESS OF THE POURING CONTAINER, FUNNEL, HOSE AND
ADAPTERS. THE OIL BEING INTRODUCED TO THE SYSTEM BY
PRIMING SHOULD PASS THROUGH A 10 MICRON FILTER.
2. After start up and operation of the V-22 hammer, check as follows:
a. Inspect the hydraulic lines for leaks.
b. Inspect the oil seal areas in the pump drive and control valves for leaks.
c. Allow hydraulic oil temperature to come up slightly above the pour
temperature, preferable to 50 degrees Fahrenheit before starting the
hammer.
d. Before attaching to a pile, open and close the clamp jaws to verify fast
and positive action.
e. Be sure that there are no kinks in the hydraulic lines and that they hang
uniformly.
f. Always maintain a close check on the lifting cable to assure no fraying has
occurred.
g. Check for overheated bearing housings.
-19-