MKS Stabil-Ion 370 Series, Инструкция по эксплуатации, Страница: 23 / 122

2 Initial Setup Procedures
2-3
Series 370 Stabil-Ion Instruction Manual - 370119
2.1.2 Convectron Pressure Units Setup
1. If you wish to change the units of measure
displayed for the Convectron gauge, change the
settings of the units of measure switches on the
module as shown in Figure 2-3 and in Figure
2-4.
NOTE: This change only affects units of measure
for a Convectron Gauge. To change the Stabil-Ion
Gauge pressure display units of measure, see Section
4.3.4.1 on page 4-12.
2. To change the units of measure label,
open the door and lift the label card
from its slot in the top of the front
panel. See Figure 2-5. Units of
measure labels are included in the
mounting hardware kit.
Figure 2-3 Control Unit Top View, Cover Off, Showing
Locations of Switches for Pressure Display
Units of Measure Selection
Figure 2-4 Pressure Display Units of Measure Switch Settings
Figure 2-5 Control Unit Front Panel Showing Removal of Units of
Measure Label Card
IG
2.13 -8
A
B
5.67 -2
745
O
I G 1
O
DEGAS
O
POWER
O
I G 2
TORR
1
2
3
4
5
6