MKS 907 Series, Инструкция по эксплуатации

Страница: 12 / 38

2 Safety
12
Series 907 Analog Convection Transducer
Instruction Manual - #109070001
2.4 High Voltage
High Voltage is present in the unit when electrical power is applied to the electronics enclosure.
Hazardous voltages may still be present for some time after disconnecting power to the electronics
enclosure. Refer to the Installation and Service chapters for more information.
High Voltage
Be aware that when high voltage is present in any vacuum
system, a life threatening electrical shock hazard may exist
unless all exposed conductors are maintained at Earth ground.
This hazard is not unique to this product.
High Voltage
All conductors in, on, or around the vacuum system that are
exposed to potential high voltage electrical discharges must
either be shielded at all times to protect personnel or must be
connected to Earth ground at all times.
High Voltage
Be aware that an electrical discharge through a gas may
couple dangerous high voltage directly to an ungrounded
conductor almost as effectively as would a copper wire
connection. A person may be seriously injured or even killed
by merely touching an exposed ungrounded conductor at high
potential.
This hazard is not unique to this product.
Do not connect or disconnect any electrical connectors while
power is applied to the equipment (hot swapping). Doing so
may cause damage to the equipment or severe electrical shock
to personnel. This hazard is not unique to this product.