1315 Storm Parkway, Torrance, CA 90501
|
P 800.421.5830
|
www.mkdiamond.com
|
F 310.539.5158
Step (6) Pre-set your hood by closing the two zippers creating
the hood shape. Make sure the Velcro, at the base, is on the
outside. This Velcro will later attach to the Velcro that is sewn
on the inside of the black pan. Grab the hood and approach the
Saw Tent from the rear of the unit. Envelope the tubular frame
structure with the clear plastic hood and make it tight. Now come
around to the front and attach the Velcro strap to the front cross
member in the middle. Next, work the plastic sheeting around
the frame, leaving the perimeter, with the Velcro outside of the
black pan. After you have attached all other Velcro pieces to the
aluminum frame, work your way around the perimeter pushing
the clear plastic sheeting (with the Velcro attached) to the inside
of the black pan. As you work your way around, you will be join-
ing the two horizontal strips of Velcro together. What this does is
make sure the water spray will run down the vertical walls and
drip inside the pan, thus containing the water. Use the handy
plug opening in the back.
Step (5) Install top supports as shown in the drawing, one in the
back, middle, and the third against the 45 degree elbow. These
three supports help keep the plastic enclosure away from the
saw and bring strength to the whole structure.
Storing
Reverse these instructions to take the Saw Tent apart. After you remove the saw and stand, use a
sponge to remove any water that has accumulated from use. Take care to clean all parts and roll up
the Saw Tent, put it into the storage case, and it will be ready to use on the next job.
SAW ASSEMBLY INSTRUCTIONS
© 2012 MK Diamond Products, Inc. All Rights Reserved. Images and specifications are subject to change without notice. Saw Assembly Instruction Sheet Part # 169658-IS (07/12)
