MK Diamond Products MK-2420HSP, Руководство пользователя и инструкции по эксплуатации

Страница: 21 / 36

21
MK-24 SERIES OPERATION
STANDARD OPERATION
The MK-24 Series is intended for industrial applications and operated by experienced professionals.
The operator must be aware of the machine’s capabilities and limitations. It is the operators respon-
sibility to use this machine under safe working conditions and conform with federal, state and local
codes or regulations pertaining to safety, air, pollution, noise etc...
(A)
Use the Depth Control Wheel to
raise the blade clear of the floor.
(B)
Attach the cooling supply hose
to the Cooling Inlet, if wet cut-
ting.
(C)
Layout and mark the area to be
cut using a chalk-line. Align Pointer
and Blade to chalk-line.
1. Prior to operation of this machine the operator must determine the existence
and location of any subsurface features that may be hazardous or could
damage the equipment, (i.e. electric cable, natural gas line etc...)
2. If the saw should stall for any reason, raise the blade out of the cut before
restarting the engine.
3. DO NOT crank engine for more than 30 seconds at a time. If engine fails to
start, wait about 2 minutes between cranking periods to prevent starter from
overheating.
4. Allow engine to warm up at least 3 minutes before applying load. When
engine is warm, throttle may be used out to maximum position. Special pre
cautions should be taken during the break-in period as specified by the
Engine Manual.
CAUTION
(D)
Place Transmission Speed
Lever in Neutral.
(E)
Verify Neutral Engagement Handle
is down, in Neutral. Choke engine
as required for cold starting.
(F)
Push Engine Throttle Handle up
half-way.