MK Diamond Products MK-1080, Руководство пользователя

Страница: 23 / 44

23
(A)
Remove spring tension on Cutting
Head by following in “Adjusting Belt
Tension” section.
(D)
Slide Cutting Head left and right on
Pivot Bar until Blade falls in middle of
slot on Table (may have to temporar-
ily replace Blade by following steps in
“Installing the Blade” section.
(B)
Loosen set Screw Collars on both
sides of Cutting Head.
(E)
Tighten Set Screw Collars on both
sides of Cutting Head.
(C)
Ensure that Table is riding correctly
on both Frame Rails.
(F)
Retension Cutting Head by follow-
ing steps in “Adjusting Belt Tension”
section.
MK-1080 PAVER SAW MAINTENANCE
DIAMOND BLADE SHARPENING (RE-DRESSING)
Like most cutting instruments, a Diamond Blade cuts best when it is sharp!
When material being cut is matched with the proper Diamond Blade, it should yield swift and accurate
cuts, and maintain an optimum operational life. NO TWO MATERIALS CUT ALIKE. Occasions may
arise where a percentage of the diamonds on the blade edge and periphery smooth “glaze” over and
the cutting efficiency is reduced. Additionally, this condition may cause the blade to “wander” or bend
in the cut, giving the illusion of an “out-of-alignment” condition. If you experience any lack of cutting
efficiency or effectiveness, sharpen your diamond blade by making several cuts into very abrasive ma-
terial, such as simple cinder block or soft sandstone. Ensure that plenty of water is used to clean cut
and cool blade.
ADJUSTING BLADE ALIGNMENT TO TABLE