11
Some Battery Tips
l
Lithium battery capacity is reduced every time they have been used.
l
MJM WHEELS™ genuine battery provides 600~800 charging cycles.
l
Stay away from extreme environment. The suggested temperature operating limits for the battery is -10C to
45C. Do not store need excessive heat.
l
Do not allow the battery to be submerged in water or to be shorted out.
l
The battery indicator bar on LCD display is only an approximate indicator of the remaining charge.
l
Frequent accelerating and braking will drain the battery charge more quickly than using it to maintain a
consistent speed ride.
l
A battery will drain about 5% for every 8 hours of being left in stand-by mode.
l
If you are not going to use the battery for an extended period of time, take out the battery and store it in a
cool, dry place.
l
Do not use battery when it has less than 10% capacity left.
l
Our bike is resistant to splashing, but not water-proof. Please do ride the bike through water deeper than
17.5 cm. The controller box will short out.
l
If you have been charging your battery for more than 12 hours and it is not yet fully charged, take it off the
charger and contact MJM WHEELS
™
.
l
The charger may get warm to the touch, so make sure you charge they are in an open area and do not lay
anything on the charger unit while charging
.
·Be friendly to the environment! Be sure to recycle your old batteries at a local battery
recycling center. Do not throw them in the garbage.
Battery Storage
How to store your battery for a extended time?
Charge the battery every 3 months to avoid capacity loss. Batteries slowly
self-discharge when left unused for a long time. If a battery is allowed to reach a
critically low voltage, their lifespan and capacity will be permanently reduced.
Always disconnect your charger from the wall outlet and battery before storing the
battery.
Avoid storing your battery in extreme temperatures, whether hot or cold.
Batteries are best kept in a cool, dry place. Do not allow batteries to accumulate
condensation, as this could cause shorting and corrosion.
