3.2. 8CH Channel
Channel
Data
Function
Mark
CH1
0~255
Dimmer
CH2
0~255
Red
CH3
0~255
Green
CH4
0~255
Blue
CH5
0~255
White
CH6
0~30
No effect
31~200
Color change
201~205
Color temperature 1 (3200K)
Can be set via menu of
“WT.xx”
......
Color temperature 2~10 (each
5 data is a color temperature)
250~255
Color temperature 11 (10000K)
CH7
0~10
No strobe
This channel can control
the speed when run the
inner program
11~255
The speed of strobe (255 is
fasterest)
CH8
0~20
Speed of dimmer 4 (slowest
and softest)
21~40
Speed of dimmer 3
41~60
Speed of dimmer 2
61~80
Speed of dimmer 1
81~99
Speed pf dimmer off (no delay)
100~109
Inner program 1
......
......(each 10 data is a program)
190~199
Inner program 10
200~240
Change light led by sound
model
241~255
Strobe by sound model
8
Speed of the Fan
The fan will be worked when the working temperature reach 40 degree,
and the speed will get the faster as the temperature get high.
Can be showed reverse display
1.2.Multi-light working in the same time
When using controller to control several lights , and using strobe , auto mode, the
controller just send the channel data . Those effect( strobe ,auto running ,fix
color)would be showed by itself. And should be attention for the follow situation:
1. There will be many situation make the light become not synchronization in
the beginning. (For example: the different time of opening the light will make them
connect the controller in different time) . And you can change the controller table
puller data( from 20 to 0, and back to 20), then it can be synchronization.
2. Due to different lights crystal frequency are not exactly equal, so it will
become not synchronization after long time.
3. If need to be synchronization for long time, there is 2 approaches:
A. Using the controller to make program make the strobe, auto run effect to
be synchronization.
B. Using the Maser/Slave model
2. Operation
2.1 Key operation
3
