MiX Telematics MVR1204, Руководство пользователя, Страница: 19 / 32

18 | P a g e
3/28/2017
Figure 5
Port C = Camera 1, road
facing
Port D = Camera 2, driver
facing
Notes :
•
The MVR1204 can be connected to either the S3 or S1 port of the FM 3xxxi series on-board computer.
•
Tracers are not supported (including the FM3x16i tracers).
3.7 Positioning the Camera in the vehicle
Please Note: Ensure that the windscreen surface is clean and dry before attaching
the camera to the windscreen. Use the alcohol swipe in the box to clean the area on
the windscreen where the camera will be mounted.
3.7.1 Camera installation in a Truck
Install the camera inside the cab, the camera should be placed against the windscreen. The position of the
camera should be one of the following:
1. Place the camera inside against the windscreen in the centre of the windscreen as close to the
bottom of the windscreen. If it is not possible to install in the centre, position the camera on the
driver side of the centre position.
2. For an optimum view, install the camera behind the path of the windscreen wiper.
3. The camera facing inside should always be higher than the dashboard to provide the best view of
the driver and co-driver. Ensure that the camera view facing outside is not blocked by a grid.
4. Ensure that the camera does not block or prevent automatic sun visors to be lowered all the way
down to the dashboard.
5. The cable should be routed along a safe path away from high voltage ignition lines sources of
mechanical damage etc. Cables should be safely secured.