Page 5 of 7
DWM-W052_User_Manual
July. 9. 2012
COMMERCIAL IN CONFIDENCE
This material may not in whole or part be copied, stored electronically or communicated to third parties
without MITSUMI ELECTRIC CO., LTD’s prior agreement in writing.
4.
Canada-Industry Canada (IC)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Labelling.
WiFi Module DWM-W052 labelled as below.
IC: 4250A-DWMW052
The proposed with IC ID label format is to be placed on the module. If IC ID is not visible when the
module is installed into the system, “Contains IC: 4250A-DWMW052” shall be placed on the outside of
final host system.
Caution:
This devise for operation in the band 5150-5250 MHz is only for indoor use to reduce the
potential for
harmful interference to co-channel mobile satellite systems.
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (EIRP) is not more than that required for
successful communication.
Exposure to Radio Frequency Radiation.
To comply with IC RF exposure compliance requirements, a separation distance of at least 20 cm must
be maintained between the antenna of this device and all persons. This device must not be co-located
or operating in conjunction with any other antenna or transmitter.
Wireless Radio Use
This device is operated in 5180~5240MHz (indoor only) and 5745~5825MHz.
