FIG. 12
TC0169e
MITSUBISHI TRITON 3 PIECE TONNEAU COVER
29/10/10
Page 5 of 13
CENTRE PUNCH AND DRILL Ø5MM HOLES AT THE PREVIOUSLY MARKED POSITIONS.
POSITION THE BOTTOM HINGES ON THE HEADER RAIL, ALIGNING THEM WITH THE PREVIOUSLY MARKED POSITIONS AS SHOWN.
MARK THE THREE (3) HOLE POSITIONS OF EACH HINGE AND REMOVE THEM FROM THE VEHICLE.
MEASURE AND MARK THE POSITIONS AS INDICATED ABOVE FROM THE CENTRE OF THE BED FOR THE PLACEMENT OF
THE BOTTOM HINGES.
WARNING:- RECHECK DIMENSIONS TO ENSURE CORRECT MEASUREMENT.
FIND THE CENTRE OF THE BED AND MARK THE POSITION.
ISSUE05
FIG. 15
FIG. 14
FIG. 13
A
B
A = B (CENTRAL POSITION)
FIND CENTRE AND
MARK POSITION
382.5mm
382.5mm
CENTRAL POSITION OF BED
MARK POSITIONS ON
TOP OF HEADER RAIL
1
ALIGN HINGE
WITH PREVIOUSLY
MARKED POSITION
MARK THREE (3)
HOLE POSITIONS
x2
11
2
11
Ø5mm
20mm
CENTRE PUNCH,
THEN DRILL Ø5MM
HOLES (x6)
