Mitsubishi RH-3SQHR3515, Инструкция по эксплуатации

Страница: 83 / 112

5Maintenance and Inspection
Maintenance and inspection procedures 5-73
(6) Timing belt tension
Fig.5-8 ： Belt tension
The timing belt can satisfactorily convey the drive and keep a durable force only when it has an adequate tension.
The belt tension should not be too tight or too lose. Instead, it should be adjusted to a degree that elasticity is felt
when the belt is pressed with the thumb. If the belt tension is too weak, the belt loosening side will vibrate. On the
other hand, if the belt tension is too strong, a sharp sound will be heard and the belt tension side will vibrate.
The detailed adjustment (tension) is shown in Fig. 5-8 .
Check and adjust with the belt pressing force f and the slack amount d between span s.
F
Pressing force
The preset value and adjustment value in the sound wave type belt tension gauge
Axis Belt type Sepang ： s mm Slack ： d mm Pressing force ： f (N)
J1 340-5GT-20 84 1.3 10
J2 363-3GT-12 103 1.6 4
J3 297-3GT-9 77 1.2 3
J4 (Motor side) 345-3GT-6 69 1.1 2
J4 (Shaft side) 312-3GT-12 82 1.3 4
Axis Belt type
Preset value
Standard tension
T(N)
M （g/m) W （mm/R) S(mm)
J1 340-5GT-20 4.0 20 84 123 ～ 151
J2 363-3GT-12 2.5 12 103 53 ～ 65
J3 297-3GT-9 2.5 9.0 77 40 ～ 48
J4 (Motor side) 345-3GT-6 2.5 6.0 69 26 ～ 32
J4 (Shaft side) 312-3GT-12 2.5 12 82 53 ～ 65
ｆ ： Pressing force
ｓ ： Span
ｄ ： Slack
T ： Tension