29
(2) Setting method of each function by wired remote controller
B: Refrigerant address
C: Data display area
D: Request code display area
TEST
CHECK
FILTER
00
01
15
FILTER
[
ON/OFF
1. Stop operation(
1
).
2. Press the button (
2
) for 3 seconds so that [Maintenance mode] appears on the screen (
A
).
After a while, [00] appears in the refrigerant address number display area.(at
B
)
3. Press the button (
3
) for 3 seconds to switch to [Maintenance monitor].
Note) It is not possible to switch to [Maintenance monitor] during data request in maintenance mode
(i.e., while “----” is blinking) since no buttons are operative.
[----] appears on the screen (
D
) when [Maintenance monitor] is activated.
(The display (
D
) now allows you to set a request code No.)
4. Press the [TEMP ( and )] buttons (
4
) to select the desired refrigerant address.
5. Press the [CLOCK ( and )] buttons (
5
) to set the desired request code No.(“311~318”, “321~324”)
6. Press the button (
6
) to perform function setting.
If above setting operations are done correctly, "Request code number will appear in data display area.(
C
)
[Example: When the "311" of "Request code number" is set, [311] appears on the screen.(
C
)]
[Refererence]
You can check current "request code number" setting by setting the "request code number"(“310” or “320”) and
pressing the button.(
6
)
[Example: When the current setting is "Setting No.2(Request code 311)", [311] appears on the screen.(
C
)]
7. To return to normal mode, press the button (
1
).
[ScreenB]
A
D
C
B
2
3
4
5
6
1
OCH492A
