Mitsubishi LANCER EVOLUTION-IV 1998, Руководство по ремонту, Страница: 260 / 526

MPI –
Throttle Body
13-37
THROTTLE BODY
REMOVAL AND INSTALLATION
Pre-removal Operation
(1) Engine Coolant Draining
(2) Air Hose D Removal
(Refer to GROUP 15 – Intercooler.)
(3) Strut Tower Bar Removal
Post-installation Operation
(1) Strut Tower Bar Installation
(2) Air Hose D Installation
(Refer to GROUP 15 – Intercooler.)
(3) Engine Coolant Supplying
(4) Accelerator Cable Adjustment
3
4
2
6
1
7
19 {1.9}
5
Unit: Nm {kgf
@
m}
5 {0.5}
Removal steps
1. Accelerator cable connection
2. Throttle position sensor connector
3. Idle speed control servo connector
4. Vacuum hose connection 5. Water hose connection
6. Throttle body
"
A
A
7. Throttle body gasket
INSTALLATION SERVICE POINT
"
A
A
THROTTLE BODY GASKET INSTALLATION
Place the gasket so that the projecting part is positioned
as shown in the illustration, and then install it between the
intake manifold and the throttle body.
Towards front
of vehicle
Up