Mitsubishi HS-S9600U, Инструкция по установке и эксплуатации

Страница: 12 / 44

8
Note A point to notice
Info.
Supplementary information
Basic Functions
2H-8H Playback mode
Audio
playback
Very
good
Picture
Quality
L12H-L40H
Good
12H/16H/24H/32H
48H-1280H/0H
Not
available
Good Fair
Very
good
When TAPE LENGTH in FIRST TIME SET UP menu is set
to T-160, the playback mode is switched in the order of 8H
L24H L40H 64H 96H 128H 160H
224H 320H 480H 640H 960H 1280H 0H
8H ...
• Picture jitter or noise may occur when the tape is played
back in L12H, L16H, L18H, L24H, L30H, L32H or L40H
mode even if the recording was made in its respective mode.
• When a pre-recorded tape is used for recording, the colored
noise may appear on the beginning of the playback picture.
• There is normal sound playback only when a tape recorded
in 2H, 6H, 8H, L12H, L16H, L18H, L24H, L30H, L32H or
L40H mode is played back in its respective mode.
When the tape reaches its end during playback/fast
forwarding
VCR’s function varies by the setting of TAPE END in the FIRST
TIME SET UP menu.
page 32 for TAPE END setting.
Rewinding a tape
While the tape is stopped, turn SHUTTLE to the left.
To stop rewinding, press STOP button.
Fast forwarding a tape
While the tape is stopped, turn SHUTTLE to the right.
To stop fast forwarding, press STOP button.
Info.
• The fast forward/rewind time of a T-120/ST-120 tape is
approximately 2 minutes, however, the time varies by the
type of a tape you use.
Audio playback and picture quality
Playback
1. Turn on the VCR and peripheral devices.
2. Load a pre-recorded tape.
3. Repeat steps 3, 4 and 9 to 13 in
Manual Recording for activating
S-VHS or S-VHS ET playback
mode and selecting the type of
tape used.
• If “S-VHS/S-ET” on
“RECORDING SET UP” menu is
set to “OFF”, a tape recorded in
S-VHS or S-VHS ET mode cannot
be played back with this VCR.
4. Press REC/PLAY MODE button to
select the desired playback mode.
5. Press PLAY button to start playback.
• If noise occurs during playback,
adjust the tracking,
page 17.
6. Press STOP button to stop playback.
Info.
• VCR automatically plays back the tape if the erasure
prevention tab is removed, AUTO PLAY.
Note
• Playback mode
– SP mode –
When TAPE LENGTH in FIRST TIME SET UP menu is set
to T-120, the playback mode is switched in the order of 2H
L12H 12H L24H 24H 48H 72H 96H
120H 168H 240H 360H 480H 720H 960H
0H 2H ...
When TAPE LENGTH in FIRST TIME SET UP menu is set
to T-160, the playback mode is switched in the order of 2H
L16H 16H L32H 32H 64H 96H 128H
160H 224H 320H 480H 640H 960H
1280H 0H 2H ...
– EP mode –
When TAPE LENGTH in FIRST TIME SET UP menu is set
to T-120, the playback mode is switched in the order of 6H
L18H L30H 48H 72H 96H 120H 168H
240H 360H 480H 720H 960H 0H 6H
...
VCR’s function
Fast
Forward
Playback
TAPE END
setting
STOP or REWIND
REPEAT or
ALARM•PROT
Stop
VCR automatically rewinds
to the beginning of the tape
and stops.
Stop
Stop
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Manual Recording (Cont.)
heard.
Recording Check Function
When the VCR is recording, press the REC CHECK button for
more than 1.5 seconds and then release. The tape will rewind a
little and then playback the recording just made. When the tape
reaches the position where the REC CHECK button was
pressed, the VCR starts recording again.