Mitsubishi FUSO FH 1997, Руководство по обслуживанию

Страница: 198 / 200

11-49
11
Ê
Tightening torque
Unit : N·m {lbf.ft, kgf·m}
Location Parts to be tightened Tightening torque Remarks
2
Bolt (Flywheel mounting) 39 {29, 4} +45
o
DŽ
5
o
Wet
03351
[Correction]
Make sure when grinding the friction surfaces for correction, that height
A is not lower than the limit while maintaining the degree of parallel with
surface B within 0.1 mm {0.0039 in.}.
A
B
A
(3) Distortion of friction surface
If the measured value is lower than the limit, repair or replace flywheel
assembly 7.
NOTE
If any fault is found in ring gear 8, replace it first, then begin
the inspection.
03350
7
8
03349
(2) Height of friction surfaces
If the measured value is lower than the limit, repair or replace flywheel
assembly 7.
A :
Height from bolt mounting surface to friction surface
7
A A
◆
Service procedure
7
Flywheel assembly
[Inspection]
(1) Wobble
If the measured value is higher than the limit, check the fastening of
bolt 2, the attachment surface of crankshaft assembly, and depending
on the condition found, either repair or replace flywheel assembly 7.
12718
2
7
-
Lubricant and sealant
Location Points of application Kinds Quantity
2
Thread area of bolt Engine oil As required
11
Lip area of rear oil seal Engine oil As required
Crankcase mounting surface of rear oil seal THREEBOND 1207C As required